AEG DPB0900W Manual De Uso página 4

4 www.aeg.com
The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than
50cm from electric cookers and 65cm from
gas or mixed cookers. If the instructions for
installation for the gas hob specify a greater
distance, this must be adhered to.
4. MAINTENANCE
ATTENTION! Before performing any
maintenance operation, isolate the
hood from the electrical supply by
switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected
through a plug and socket, then the plug
must be removed from the socket.
The cooker hood should be cleaned
regularly (at least with the same frequency
with which you carry out maintenance of the
fat fi lters) internally and externally. Clean
using the cloth dampened with neutral liquid
detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
Warning! Failure to carry out the basic
cleaning recommendations of the
cooker hood and replacement of the
filters may cause fire risks.Therefore,
we recommend observing these
instructions.
The manufacturer declines all responsibility
for any damage to the motor or any
fi re damage linked to inappropriate
maintenance or failure to observe the above
safety recommendations.
4.1 Grease fi lter - The grease fi lter must
be cleaned once a month using non
aggressive detergents, either by hand or
in the dishwasher, which must be set to a
low temperature and a short cycle. When
washed in a dishwasher, the grease fi lter
may discolour slightly, but this does not
affect its fi ltering capacity.
5. CONTROLS
The hood is equipped with a control panel
with a light turning on/off key and an air
inlet valve opening/closing key.
1. ON/OFF lights
2. "I" = Valve Opening
"O" = Valve Closing
OFF!
ON!
Note: In order to work properly, this product
should be connected to an external suction
unit.
6. LIGHTING
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs
ensure they are cooled down.
Replace the old light bulb with the one of
the same type as specifi ed in the feature
label or near the light lamp on the hood
(E14).
2 1