Enabling The Ir Repeater Function (When You Cannot Control The Tv) - Sony HT-RT5 Manual De Instrucciones

Enabling the IR Repeater
Function (when you
cannot control the TV)
When the Bar Speaker obstructs the
remote control sensor of the TV, the TV
remote control may not work. In that
case, enable the IR repeater function of
the system.
You can control the TV with the remote
together with the supplied IR blaster.
Note
• Be sure to check that the remote control of
the TV cannot control the TV, and then set
[IR-Repeater] to [On] (page 28). If it is set to
[On] when the remote control can control
the TV, appropriate operation may not be
obtained because of the interference
between the direct command from the
remote control and the command via the
system.
1
Connect the supplied IR blaster to
the IR BLASTER jack of the Bar
Speaker.
38
US
IR blaster
2
Place the IR blaster close to the
remote control sensor of the TV,
aiming the IR emitter of the IR
blaster at the remote control sensor
of the TV.
Make sure that the IR repeater
function is working before securing
the IR blaster on the Bar Speaker with
the double-faced adhesive tape
supplied.
3
Press HOME.
The home menu appears on the TV
screen.
4
Select [Setup] -
Settings] from the home menu.
5
Select [IR-Repeater].
6
Select [On].
Notes
• Refer to the operating instructions of your
TV for the location of the remote control
sensor.
• Connect the IR blaster before connecting
the AC power cord (mains lead) of the Bar
Speaker.
• Do not connect the IR blaster to a
headphone jack, etc. of the TV.
• Do not use the IR blaster for any other
purposes.
• On some TVs, this function may not work
correctly. In this case, place the Bar Speaker
slightly further away from the TV.
[System