Bosch BX1 Instrucciones De Uso página 13

en
Insert the filter frame into the filter cartridge and click into
place, in the direction of the arrow.
Cleaning the motor protection filter
22
Figure
Open the motor protection filter flap.
Remove the micro filter and shake it clean.
If it is very dirty, the motor protection filter should be
rinsed. The motor protection filter can even be cleaned in
the washing machine at 30 °C on a delicates cycle.
A replacement micro filter may be ordered via the After
Sales service.
Replacement part number: 642879
CAUTION: The vacuum cleaner must only be
!
operated with the motor protection filter, foam filter
and fluff filter fitted.
The filters must be completely dry before they are
refitted in order to ensure that they function correctly
and to prevent the formation of odours or bacteria
(wait about 24 hours)
23
Figure
Fit the dust container into the vacuum cleaner (make sure
it is fitted correctly).
Push the cylinder back into position, closing the vaccum
cleaner (you will hear a positive click).
CAUTION: The cylinder can only be engaged if the
!
dust container is fitted correctly.
Cleaning the washable exhaust filter
(made by Schwarzvlies)
24
Figure
Open the exhaust filter cover.
Remove the exhaust filter.
25
Figure
Clean the exhaust filter by knocking out the dirt.
If the exhaust filter is very dirty, it should be rinsed out (or
washed in the washing machine at 40°C).
Fit the exhaust filter.
Close the exhaust filter cover.
CAUTION: The filter must be completely dry before it
!
is refitted in order to ensure that it functions correctly
and to prevent the formation of odours or bacteria
(wait about 24 hours).
The exhaust filter may be ordered via our After Sales
Service.
Replacement part number: 642881
12
Cleaning the cylinder and joint
26
Figure
Use the release button to unlatch the cylinder. The
cylinder folds forward (see Fig. 17).
Turn the dust separator twist-lock cover anticlockwise
and remove it from the dust separator.
Clean the cylinder and cylinder cover as required.
27
Figure
Replace the dust separator twist-lock cover and lock into
position by turning in a clockwise direction.
Push the cylinder back into position, closing the vacuum
cleaner (you will hear a positive click) (see Fig. 23).
28
Figure
The cylinder can also be removed from the vacuum
cleaner to clean the joint in the event of malfunctions
caused by large objects being vacuumed up.
When replacing the joint, you must hear it engage.
CAUTION: The inside of the separator may become
!
scratched with use and start to look opaque. This
does not, however, affect the performance of the
vacuum cleaner in any way, i.e. it will continue to
function as normal.
Care
Always switch off the vacuum cleaner and disconnect the
power cord from the mains before cleaning the appliance.
The vacuum cleaner and plastic accessories can be
cleaned with a commercial plastic cleaner.
Do not use a scourer, glass-cleaning agent or all-
!
purpose cleaning product. Never immerse the
vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned with a
second vacuum cleaner or simply wiped with a dry cloth or
dusting brush.
Subject to technical modifications.