Idiomas disponibles
Idiomas disponibles
Operation
Operating times
z Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
z Please feed cable through the strain relief
Hang up collection bag
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the reces-
ses (see arrow).
3. Replace the protective flap.
Set cut height
M
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
1. Pull the lever out (1).
2. Set the desired cutting height (2).
3. Press the lever back in (3).
3
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf.
Do not se cutting position too low when mowing very hight
or wet grass.
Connecting to the mains (230 Volts, A.C., 50 Hz)
z The mower operates from any normal household mains sup-
ply, provided with a 16 Amps. fuse.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
z We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
z Retrofit kits are available for old installations. Consult an
electrician.
Starting and Stoping
z Switch on motor with mowerplaced on level and firm ground.
z not in high grass - alternatively tilt slightly
Switch-on motor
O
1. Depress button and hold (1).
2. Lift up bar (2).
3. Release bar (1).
12
K
K
.
L
N
.
Switch-off motor
O
z Release bar (2).
Emptying of Grassbox
When the collection bag is full, the flap lowers by itself
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z Empty collection bag.
z Remove potential blockages in the cutting space before
starting.
3
Instructions for level indicator:
For an efficient functioning of the level indicator, regularly
clean the holes under the level indicator in the collection
bag with a hand brush.
Mulch (AMBITION 38 E, AMBITION 42 E)
„Mulching" is a process in which the grass is finely chopped by a spe-
cial cutting system and then deposited on the ground. The result is
that the grass does not have to be collected and disposed of. „Mul-
ching" also prevents the lawn from drying out.
3
Instructions for mulching
We recommend:
z Depending on the growth of grass, mulch 1 – 2 x per week
z The grass should not be too high nor too wet!
z Go slow while mulching
z Take care that the blade channels do overlap.
z Do not cut grass more than 20 mm.
3
Note:
Mulching is not advisable in case of moss-affected or
entangled grass, because the cut material stays on the moss
surface and/or entanglement and thus cannot be absorbed by
the ground.
z Regularly scarify and manure the lawn.
Retrofitting for mulching
1. Lift the ejection flap.
2. Remove the grass catcher.
Q R
3. Insert mulch key
4. Lower the ejection flap.
Tips for mowing
z To prevent strips of grass from being left unmowed, the cutting
paths must always overlap a few centimeters
z Always let cable trail on the cut side of the lawn.
P
S
.
T
.
.
G
Capítulos
