Maxon C2 Manual De Instrucciones página 10

Ocultar thumbs Ver también para C2:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

NOTE: Ensure the 2 loose mounting angles are butted against the rear rail of the truck
body.
1. Clamp 2 loose mounting angles in de-
sired position on bottom or side of long
sills at rear of truck body. (FIG. 10-1).
2. Bolt (Kit items) or weld each of a
mounting angle to each of the long sills
(FIG. 10-1). Then, weld each of the 2
mounting angles on the long sills, to
the mounting angles on the bottom of
the liftgate main frame housing.
3. Then, weld each of the 2 mounting angles
on the long sills (FIG. 10-1), to the mount-
ing angles on the bottom of the liftgate
main frame housing.
4. Ensure liftgate is level as shown in FIG. 9-2.
If levelled correctly, tip of platform will touch
the ground and there may be a small gap
between the top of each column and the
truck body (FIG. 9-2).
5. Check the rear of the main frame housing
on the liftgate. Ensure the electrical cable
strain relief is not obstructed. Electrical pow-
er cable for liftgate must be pulled out from
main frame through the strain relief.
6. When lower mounts are bolted or welded in
place, and liftgate is levelled correctly, con-
tinue by installing the upper mounts.
LIFT CORPORATION Sht. 10 of 36 DSG#
INSTALL LIFTGATE - LOWER MOUNTS
REAR RAIL
ANGLES
(POSITION 1)
LONG SILL
(2 PLACES)
POSSIBLE POSITIONS FOR MOUNTING
ANGLES AT REAR OF TRUCK BODY
M-14-34
Rev. A Date: 03/03/17
ANGLES
(POSITION 2)
FIG. 10-1
ANGLES
(POSITION 3)
Tabla de contenido
loading

Tabla de contenido