Preparing the unit
Inserting batteries
You can use the following batteries.
ˎ
Two LR6 (size AA) alkaline batteries
ˎ
Two AA Nickel-Metal Hydride batteries
1 Turn this unit off by sliding the ON/OFF
(power) switch to OFF.
2 Open the battery cover.
¦
Note
ˎ
Be careful not to pull or exert a force on the foot of
this unit when opening the battery cover. Doing so
can cause a malfunction.
3 Insert the batteries into the battery
compartment according to the marks
inside the compartment.
4 Close the battery cover.
¦
Notes
ˎ
The batteries inserted in this unit only power this
unit. They cannot power or charge the camera.
ˎ
Be careful not to touch the multi connector when
holding this unit.
ˎ
You cannot use manganese batteries.
ˎ
Always use the same kind of batteries together.
ˎ
Check the polarities of the batteries when inserting
them into this unit. If you insert the batteries in the
wrong direction, this unit does not work.
ˎ
Do not use a new or charged battery together with
a dead battery.
To remove batteries
Turn this unit off and then remove the batteries.
¦
Note
ˎ
When removing the batteries, be careful they do
not fall and cause injury.
¼
Tip
ˎ
Remove the batteries if this unit will not be used
for a long period of time.
Battery level
If the battery level is low, the operation/battery
indicator flashes slowly. If the battery level gets
lower, indicator flashes more rapidly and this unit
automatically enters standby mode.
7-GB