Orbis CODITEL 2 Manual Del Usuario página 41

• Set operation mode button (for admin only)
A quick press of the button allows it to act on the output.
To define the mode of behavior output using the command:
OUTKEY [functionality] with functionality that can assume the values:
− RING  it reacts as it does to a call when the key is pressed
− TOGGLE  the key switches the output ON/OFF in bistable mode
− BLOCK  disables the key functionality (it is not possible to access programming
mode when in this mode)
If the value is omitted, the current instrument status will be the response.
The default setting is RING.
• Caller control activation/deactivation (for admin only)
The caller number control can be disabled if you wish to temporarily allow anyone to
command the outputs via the command:
RINGCONTROL [status]
− ON  activates a control of the caller to check it is enabled
− OFF  disables the caller control function
If the value is omitted, the current instrument status will be the reply.
• Activation/deactivation of a text message of reply to a ring (for admin only)
A function can be activated to receive a text message following a ring, containing the
response of the instrument upon receiving the call with the command:
RINGRISP [status] with status that can assume the values:
− ON  sends a text message to the caller on the response of the outputs to the ring
− OFF  no text message will be sent as reply
If the value is omitted, the current instrument status will be the reply.
• Defining the response to a ring (for admin only)
The response of the outputs to a ring from an enabled telephone number can be defined
through the command:
with status that can assume the values:
- 39 -
User Manual CODITEL 2