Assembly And Adjustments - DeWalt DWD024 Manual De Instrucciones

English
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. D
if this tool does not operate, check power supply.
COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
Intended Use
These heavy-duty V.S.R. drills are designed for professional
drilling.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
These heavy-duty drills are professional power tools.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Side Handle (Fig. A)

WARNING: To reduce the risk of personal injury,
ALWAYS operate the tool with the side handle
properly installed. Failure to do so may result in
the side handle slipping during tool operation and
4
or AC ........... alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n ........................ no load speed
o
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
WALT tools are factory tested;
e
subsequent loss of control. Hold tool with both hands
to maximize control.
A side handle comes assembled with the DWD024. The
side handle 7 can be fitted to suit both right-hand and
left-hand users.
To adjust the side handle
1. Loosen the side handle 7
counterclockwise.
2. Rotate the side handle to the desired position.
3. Tighten the side handle by turning it clockwise.
To change sides
For right-hand users: slide the side handle clamp over the
chuck, handle at the left.
For left-hand users: slide the side handle clamp over the
chuck, handle at the right.
Forward/Reverse Button (Fig. A)
The forward/reverse button 3
from tight holes and removing screws. It is located above
the trigger switch.
To reverse the motor, release the trigger switch FIRST and
then push the lever to the right (viewed when holding the
drill in the operating position).
After any reversing operations, return lever to
forward position.
Mode Selector (Fig. B)
NOTICE: Tool must come to a complete stop before activating
the mode selector button or damage to the tool may result.
Select the required operating mode by sliding the mode
selector 9 to the corresponding symbol.
Fig. B
9
Drill-Only mode
Use drill-only mode for wood, metal,
and plastics.
Hammer-only mode
Use hammer-only mode for simultaneous
rotating and impacting for masonry, brick
and concrete.
Setting the Drilling Depth (Fig. C)
1. Insert the required drill bit into the chuck.
2. Loosen the side handle 7
3. Fit the depth adjustment rod
side handle clamp.
by turning it
is used for withdrawing bits
.
8 through the hole in the