Programming; Programming Custom Chip; Machine Assembly; Lid Assembly - Vitamix BARBOSS ADVANCE Manual De Uso Y Cuidado

P R O G R A M M I N G
The BarBoss® Advance® and Drink Machine Advance® are pre-programmed
with settings optimized for the Advance® container. The programs can be
customized by using a programming chip or programmer software kit available
from Vitamix®. Call your distributor or Customer Service for more information.
Although your machine comes from the factory pre-set with the programs,
follow these instructions when using a custom programming chip.
Programming with a Custom Chip
1. Turn the power to the machine on using the On/Off switch located
on the front of the machine below the control panel.
2. Remove the container and lift the front of the machine so that you can
see the bottom programming port. Facing the front of the machine, insert
the custom programmed chip with the silver contact bars up and the words,
"THIS SIDE FACING TO THE FRONT OF THE MACHINE" toward you into the
port located below the label area.
3. Within 5 seconds, the six Pre-Set Programs will be re-programmed.
4. Remove the programming chip, return it to the original package and store
in a safe, easily accessible spot.
5. Place the machine back on its feet and replace the container.
Programming Port for the BarBoss Advance
and Drink Machine Advance.
6 ft. / 1,8 m Power Cord can be stored
neatly underneath when not in use.
Retainer Clips are flexible and will return to position after
cord is lifted out. There is no need to unscrew the clips to
let out more cord.
BOTTOM OF
MACHINE
Resetting Pre-Set Programs to original factory settings
1. Turn the power to the machine off using the On/Off switch
located on the front of the machine below the control panel.
2. Hold down the pulse button while turning the power back
on using the On/Off switch.
IMPORTANT NOTES!
Programming Chip: If the above programming steps are taken and the custom
programming does not appear with the first blend cycle, turn the chip 180˚
(side-to-side ) and try again.
10
M AC H I N E ASS E M B LY
FIGURE A FIGURE B

Lid Assembly

Two-Piece Lid, (Figure A) 32 oz. / 0,9 L Advance® Container
• The two-piece lid is easy to clean and easy to put on, take off and seal.
• To remove a fully latched lid, lift the two tabs and pull upward and off.
• Twist the center lid plug to fasten or remove.
One-Piece Lid, (Figure B, optional) 32 oz. / 0,9 L Advance® Container
• The one-piece lid is easy to clean and easy to put on, take off and seal.
• There is no lid plug for this lid.
• Add ingredients through port on top.
IMPORTANT NOTES!
Containers:
• BarBoss Advance and Drink Machine Advance machines are optimized for use
with the Vitamix 32 oz. / 0,9 L Advance container. Use of Vitamix Standard
containers (64 oz. / 2,0 L, 48 oz. / 1,4 L or compact 32 oz. / 0,9 L) may require
programming adjustments. The 32 oz. / 0,9 L Advance container will not work
with earlier Vitamix models. Call Vitamix Customer Service or your distributor for
more information.
• Outside the United States and Canada, your machine may come
with a different container configuration.
New Lids: To make new lids easier to insert and remove, rub a light coating of
cooking oil around rim where it seals. Place it in container for several minutes,
remove and lightly wipe oil off lid.
11