Continuous Fogging; Controlling Several Devices Via One Remote-Control; Dmx-512 Control - EuroLite NB-150 ICE Manual Del Usuario

Continuous fogging

By pressing the Continuous-button, the device produces continued fog. The continued fog is only interrupted
by necessary heating pauses. The green LED below the Continuous-button shows that the Continuous-
function is activated. If you wish to deactivate the Continuous-function, press the Continuous-button again.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.

Controlling several devices via one remote-control

You can control several NX-150 with one remote-control. If two or more device are connected, they will work
similarly.
Only use a stereo shielded cable and 5-pin XLR-plugs and connectors in order to connect one device with
another.
Connect the Remote Control with the Remote Control-input of the first device. Connect the Remote Control-
output of the first device with the Remote Control-input of the next device. Always connect one output with
the input of the next device until all devices are connected.

DMX-512 control

The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the device or one device with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first device in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first device in the DMX-chain with the DMX-input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution: At the last device, the DMX-cable has to be terminated with a terminator. Solder a 120 resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last device.
20/40 00033330.DOC, Version 1.1