Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATION OF THE TORCH BUTTONS
MAIN BUTTON SW1
This button activates the welding sequence (all the steps of the curve). The welding current is A1. We can set the
sequence in 2T or 4T mode.
SECONDARY BUTTON SW2
If you press this button at the welding start, the machine will be set to DOTTED mode "FULL POWER POINT" (FPP).
It will start the arc without start and stop ramps. It is very useful for attachment points at the beginning and end of a
weld. If the arc is initiated with SW1, SW2 button will change between the current A1 and the current A2, enabling a
manual pulsed arc. In 4T mode, the button allows the double balance mode (the welding current is reduced to a
percentage previously scheduled in P.05).
REMOTE CONTROL
Using a torch with remote control is possible to change the welding current from the minimum to the value specified in
the control panel of the equipment.
SPECIAL FEATURES
The special functions settings menu is accessed by pressing the mode selector button for 4 seconds until F.00 appears
on the display screen.
Num.
Val
Description
P00
0
Access code for technical service
P01
OFF
Enable shut down mode of display after 10 minutes of inactivity.
If weld restarts, the equipment is automatically reactivated.
P02
ON
Visualization process of TIG welding enabled. TIG welding sequence is shown in the display
P03
OFF
Investment of SW1 and SW2 buttons
P04
ON
Enable/Disable the remote control
P05
30
Adjusting % of double balance (only active in TIG 4T mode)
P06
35
Initial current in TIG HF mode. Current to preheat the electrode, it can be increased for better start of
electrodes above 2.4mm. This current is only applicated a split second.
P07
OFF
Enable the Pilot-Arc function, only for TIG 4T mode
P08
0
Selecting the cooler's working mode.
0 = Automatic. It will be launched if you have connected. The cooling time depends on the use.
1 = always on.
2 = Always off. Enable this mode only if you use not cooled torches
The handling of internal parts of the machine should be performed only by qualified personnel. There is a risk of
electric shock on contact with live parts. You should NOT operate without the covers properly placed. Before
accessing the interior of the machine, unplug it from the mains and wait at least 5 minutes before carrying out any
SOLTER SOLDADURA S.L.
ATTENTION
maintenance.
11
Capítulos
Tabla de contenido
