Blackmagic Design Teranex Mini Instrucciones De Funcionamiento página 78

SDI Audio Selection Table
By using the following combinations of switch settings, you can select which SDI audio channels
to output as analog or digital AES/EBU audio with your Teranex Mini – Optical to Analog 12G.
Analog Audio Channels
1 and 2
3 and 4
5 and 6
7 and 8
9 and 10
11 and 12
13 and 14
15 and 16
AES/EBU Audio Channels
1-4
5-8
9-12
13-16
Blackmagic Teranex Setup Settings
The Teranex setup utility can change all the same settings that are available using the switches,
plus additional settings.
You can access these settings by moving between the 'video,' 'audio,' 'configure,' and
'about' tabs.
The 'about' and 'configure' tabs are detailed in the 'changing settings' section in this manual.
The 'video' tab for Teranex Mini – Optical to Analog 12G contains the following settings.
Video Output Menu
This lets you pick between component, or s-video and composite video output as well as
setting the luminance and chroma levels, and the B-Y and R-Y component levels independently.
If you have selected s-video and composite output, you can additionally choose between 7.5
IRE and 0.0 IRE black levels, depending on the region you are working in. If you have selected
component video, you can switch between SMPTE and Betacam levels. SMPTE levels are more
common and even Betacam SP decks can use SMPTE levels, so only switch this to Betacam if
you are sure that Betacam levels are being used.
Switch 4
Switch 3
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
Switch 4 Switch 3
OFF OFF
OFF OFF
OFF ON
OFF ON
Switch 2
Switch Diagram
OFF
ON
OFF
ON
OFF
ON
OFF
ON
Switch 2 Switch Diagram
OFF
ON
OFF
ON
Teranex Mini – Optical to Analog 12G 78