Installing The Optional Speaker/ Microphone; Charging The Battery Pack - Kenwood TK-2302 Manual De Instrucciones

INSTALLING THE COVER OVER THE SPEAKER/ MICROPHONE
JACKS
Speaker/ microphone
jack cover

INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE

(OR HEADSET)
Speaker/ microphone locking
bracket

CHARGING THE BATTERY PACK

The battery pack is not charged at the factory; charge it before use.
ATTENTION: Always switch OFF a transceiver equipped with a
battery pack before inserting the transceiver into the charger.
4
If you are not using a speaker/
microphone, install the cover over
the speaker/ microphone jacks using
the supplied M2.6 x 7 mm screw.
Note: To keep the transceiver water
resistant, you must cover the speaker/
microphone jacks with the supplied
cover.
1 Insert the speaker/ microphone
(or headset) plugs into the
speaker/ microphone jacks.
2 Attach the locking bracket using
the supplied M2.6 x 7 mm screw.
Note: The transceiver is not fully
water resistant while using the
speaker/ microphone.