TaoTronics TT-BA09 Manual De Usuario página 6

Note:
• In order to achieve low latency, please make sure your receiving
Bluetooth device also support Qualcomm® aptX™ Low Latency
codec, otherwise you may experience noticeable lag between
sound and picture.
• Please make sure your optical cable is plugged in SPDIF IN
port/AUX in TX mode.
• Please do not connect TT-BA09 to an amplifier output in TX mode,
which may cause over-voltage and damage the adapter.
Pair in RX mode:
1. Set the TT-BA09 to RX mode and connect it to your non-Blue-
tooth audio receiving device.
2. Turn on the TT-BA09 and tap the Power Button twice to enter
pairing mode.
3. Activate the Bluetooth® function on your transmitting device –
phone / tablet, and search for the nearby Bluetooth® devices.
4. Find "TaoTronics TT-BA09" in the search results and tap on it to
connect. Once connected, the LED indicator will turn solid blue.
Note:
• The adapter will enter pairing mode automatically when
powered on for the first time.
• The original pairing memory will be cleared after a mode switch.
It will automatically start pairing each time it's powered on.
• The adapter can remember previously paired devices and will
attempt to pair with devices automatically, without going into
pairing mode.
• Please make sure your optical cable is plugged in SPDIF OUT/AUX
port in RX mode.
Pair with two devices at the same time
In TX mode:
• In TX mode, the adapter is able to pair with two Bluetooth stereo
earphones/speakers at the same time.
1. Follow the previous instructions in the "Pairing" section to pair the
TT-BA09 with your first device.
2. Turn off the Bluetooth function on your first device, tap the Power
Button twice to pair and connect to your second device.
3. Turn on the Bluetooth function on your first device. In
approximately 10 seconds, the first device will automatically
connect in.
Note:
• When you pair with two devices, both can play music at the same
time.
• The adapter will automatically re-pair when powered on.
05/06