Amate Audio TPD Manual De Usuario página 8

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

TPD
Fig. 3. Available loudspeaker connectors on the rear panel
Binding Posts: They accept direct cable connection up to 8mm
The Binding Posts are marked with Red for the Positive Pole, and Black for the
Negative Pole. Separate outputs are available for each channel: 2 binding Post
(RED/BLACK) for SW, 2 for L and 2 for R.
The outputs are configured as following:
Output
SPEAKON
Binding
Post
Table 2. Configuration of loudspeaker connections
WARNING: high risk of malfunction or major damage!
As specified in the previous point, there is the possibility to use
simultaneously the different outputs, such as SPEAKON and the Binding
Posts. Please make sure to check that the total load connected to each
channel is not below 4 Ohm, since all outputs are connected in parallel.
Be extremely careful when performing the connections, as a shortcircuit between any
of the "live" pins (see Table 2) can damage the amplifier or even cause the
destruction of one or both power modules.
4.3 Connection of the inputs/auxiliary outputs
The inputs and auxiliary outputs enable connection through XLR-3 connectors. The
amplifier incorporates balanced inputs for a high rejection of noise generated by long
signal cables, proximity to electric wires or sources causing them.
The auxiliary outputs enable the interconnection of other amplifiers to the TPD
internal processor, which enables 3 independent processing channels.
8
SW
Positive
+1 (live)
Negative
-1 (live)
Positive
RED
Negative
BLACK
2
section (8AWG).
L
R
+1 (live)
+1 (gnd)
-1 (gnd)
-1 (live)
RED
RED
BLACK
BLACK
Jul 2016
Amate Audio
Tabla de contenido
loading

Tabla de contenido