Amate Audio TPD Manual De Usuario página 28

TPD
8 TROUBLESHOOTING
8.1 How to perform a firmware upgrade
To perform a firmware upgrade, proceed as following:
1. Connect the unit to the computer
2. Using DSPLink, enter the Device Main Window
3. Choose "Hardware > Enter Password"
4. Enter the administrator password (see next chapter)
5. Go to "Hardware > Firmware Upgrade"
6. Follow the on-screen instructions
7. Select whether you want to perform a backup of the user presets to recover
them after the upgrade
8. The unit will restart and will ask to load a Factory File. Select "yes" and load
the file in the selected folder.
IMPORTANT: The unit will not operate properly without a loaded factory
file
9. Finally, the unit will restore the user presets.
10. Restart the unit.
8.2 Password recovery
The unit is shipped unlocked, so no password will be necessary unless the unit is
locked by the user. The default user password is "Password".
In case this Password has been changed by the user (Using the Menu "Hardware >
Configure > Change Password") and is no longer remembered, a Firmware Upgrade
is needed to re-establish the password to the default value (see previous section).
The Admin password is "AMT_adm".
WARNING: The admin password gives you privileges to change vital
information of the processing. A wrong setting may damage the amplifier
and /or the loudspeakers, excluding any warranty on the equipment.
28
Jul 2016
Amate Audio