Innotek FieldPro FP-RANGER-E Manual Del Propietário página 16

Two Dog Systems
If you wish to add another receiver collar
to the training system, accessory
receiver collars are available where you
bought your training system, or contact
an authorized INNOTEK Service Center.
Using the first Receiver collar, set your
Transmitter to Dog 1 and turn the
Receiver collar on with the Tone button.
Set the first Receiver collar down.
Holding the second Receiver collar, set
your Transmitter to Dog 2, and turn on
Receiver collar Two. The Transmitter will
send a signal to the Dog symbol
appearing in the Transmitter's display. To
switch between Receiver collars, press
the Dog Select button until the desired
dog symbol displays.
Dog 1 symbol
EN-16
Dog 2 symbol
Testing the Receiver
In order to make sure the Receiver is
getting signals from the Transmitter, you
may wish to test the Receiver from time
to time.
To test:
1 1 . . Hold the included Test Light across
the Receiver's contacts. (Refer to
the illustration at the bottom of this
column, the holes in the Test Light
go over the contact tips; make sure
the wire inside the hole touches the
contact tip.)
2 2 . . Press the Stimulation button on the
Transmitter.
3 3 . . The Test Light lights up. The
intensity of the Test Light depends
on the stimulation level. The light is
dim for low stimulation levels and is
brighter for higher stimulation levels.
Light
Receiver contacts touch
wires inside these holes.
FieldPro-E Owner's Manual