SEVERIN ES 3561 Instrucciones De Uso página 8

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
Useful information
- To position it firmly, we recommend
pressing the appliance lightly down onto
the work surface before use; this will
ensure that the suction feet are firmly
attached to the surface.
- This appliance allows natural, vitamin-
rich juices to be extracted from fruit and
vegetables.
- To preserve the maximum vitamin
content, the juices are best drunk fresh, ie
immediately after extraction.
To store, place the fresh juice in the
refrigerator in a covered container.
- It is advisable to use glass or plastic
containers, since metal containers might
affect the taste.
- After cleaning, cut up the fruit or
vegetable so that it fits down the feeder
tube. Before extracting juice from fruit or
vegetables with stones, please remove
any stones to prevent damage to the
appliance; in addition, removing the
cores optimises the juice extraction.
- The following fruits and vegetables are
not suitable for juice extraction: figs,
grapes,
avocados,
raspberries, blackberries, currants,
elderberries, rhubarb, blueberries,
cranberries, beetroot etc.
- Tomatoes should be lightly carved in
with a knife before juice extraction.
- Bananas should be added for aromatic
purposes only, as very little juice can be
extracted.
Short-time operation
The appliance has been designed for short-
term operation only, i.e. it should not be
operated continuously for more than 2
minutes at a time. Switch off the appliance
afterwards and allow the motor to cool
down before switching it on again.
Before using for the first time
- Before the appliance is used for the first
time, it must be cleaned as described in
the section General Care and Cleaning.
Switch
The appliance is equipped with a 3-position
switch.
0
1
2
We recommend starting extraction with the
slow setting and switching to the faster
setting only when necessary.
Operation
- Place the pulp container onto the holding
- Fit the juice outlet insert onto the drive
- Fit the filter and grating plate insert onto
- Place the transparent lid onto the juice
aubergines,
- Place the juice container directly
- Insert the plug into the wall outlet and set
- Feed the cleaned and pre-cut fruit or
- When processing large quantities of fruit
- After use, switch the appliance off and
General Care and Cleaning
8
appliance switched off
slow juice extraction
fast juice extraction
platform on the side of the drive unit.
unit.
the drive shaft coupling and push the
insert down until it is heard locking into
place. It is essential that the filter is
properly locked; otherwise, if it is not
correctly connected to the drive shaft,
damage may occur during operation.
outlet and use the two locking clamps to
lock the lid to the drive unit; this will
activate the safety switch. If the clamps
are not securely locked, the safety switch
will prevent the motor from operating.
underneath the juice outlet.
the switch to the required setting.
vegetable pieces down the feeder tube
while the unit is running. Use the pestle
and lightly push the pieces down.
Excessive pressure may result in damage
to the motor or grating plate!
or vegetables, the pulp container and
juice container must be emptied from
time to time as necessary.
remove the plug from the wall socket.
Always remove the plug from the wall
socket and allow the appliance to cool
loading