Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Testing for Bladder Leakage
1. Disconnect power to pump.
2. Drain water from tank bladder by opening
faucet closest to tank.
3. Remove valve cap and release all pressure by
depressing valve core. When air stops coming
from valve, remove valve core to release
remaining pressure.
4. Disconnect piping from elbow on tank
cover flange.
5. Carefully turn tank upside down or lay on
its side.
Heavy parts . Retained water in tank
may cause sudden weight shift when lowering.
Support tank so it cannot fall when being lowered
or inverted.
6. If bladder leaks, water will run out of valve. If
so, replace bladder.
7. If replacing bladder, be sure air and water
pressures are relieved before removing cover
flange. When reassembling cover flange, do
not tighten nuts or mounting studs more than
65 in-lbs.
Model
20-40 PSI (138-276kPa)
CLPT20
CLPT20H
CLPT36
CLPT52
CLPT85
CLPT119
Maximum
Model
Capacity US
Gals (L)
CLPT20
19 (72)
CLPT20H
19 (72)
CLPT36
35 (132)
CLPT52
50 (189)
CLPT85
85 (322)
CLPT119
119 (450)
* Length overall; this model is a horizontal tank.
Product Information – Pre-Charged Tanks
6.9 (26.1)
6.9 (26.1)
12.7 (48.1)
18.3 (69.3)
30.0 (113.6)
41.3 (156.3)
Equivalent to
Standard Tank
US Gals (L)
42 (159)
42 (159)
82 (310)
120 (454)
220 (833)
320 (1211)
Figure 5 - Typical installation with vertical pre-
charge tank and submersible well pumps
NOTICE When using metal pipe with plastic
fittings, use only PTFE pipe thread sealant tape
on male threads.
NOTICE Most standard tanks have separate inlet
and outlet ports. Pre-charge tanks have one port
serving both functions. When replacing standard
tank with a pre-charge tank, run pipe from pump
into a tee as shown. Second leg of tee goes to
tank elbow. Third leg goes to existing service.
Drawdown - Gals (L)
30-50 PSI (207-345kPa)
5.8 (22)
5.8 (22)
10.7 (40.5)
15.5 (58.7)
26.0 (98.4)
35.4 (134.0)
Tank Diameter
(mm)
16" (406)
16" (406)
20" (508)
24" (610)
24" (610)
24" (610)
40-60 PSI (276-414kPa)
5.0 (18.9)
5.0 (18.9)
9.3 (35.2)
13.4 (50.7)
22.0 (83.3)
31.0 (117.3)
Tank Height
Tank Discharge
(mm)
30-1/8" (765)
*24-5/8" (625)
36-1/4" (921)
34-3/4" (883)
54" (1372)
68" (1727)
6
Tapping
1"
1"
1"
1-1/4"
1-1/4"
1-1/4"
Tabla de contenido
