Cleaning Your Mr. Coffee ® Café Barista - MrCoffee BVMC-ECMP1000 Serie Manual Del Usuario

a.
x1
NOTE: For a small cup, use the single shot filter. For a large cup, use the
double shot filter.
IMPORTANT: Make sure to clean the Frothed Milk Dispensing Tube after use.
See Cleaning instructions on page 15 for instructions.
TO ADD ADDITIONAL FROTHED MILK / FROTH MILK SEPARATELY
®
The Mr. Coffee Café Barista also allows you to manually add more frothed
milk to your beverage or froth milk separately. To add more frothed milk to
your beverage, place your beverage on the unit and ensure the Frothed Milk
Dispensing Tube is aimed towards the center of your cup. Next, Press and Hold
the Cappuccino Button " " for 3 seconds and the unit will begin to add more
frothed milk. When done, press the Cappuccino Button "
stop the unit. For frothing milk separately, follow the same instructions but
place an empty cup on the unit instead. The frothed milk can be used for
macchiato, hot chocolate, chai latte, etc.
BVMC-ECMP1000_BVMC-ECMP1001_13ESM1.indd 15-16
b.
x2
" once again to
hold for
3 sec.
14
CLEANING YOUR CAFÉ BARISTA
CLEANING THE MILK RESERVOIR AND FROTHED MILK
DISPENSING TUBE
Once you are done preparing your beverage with milk, you can either store
the unit's milk reservoir with milk directly in the refrigerator OR completely
clean the milk reservoir.
If storing your milk reservoir with milk in refrigerator, follow
these cleaning instructions:
1. Place a large empty cup under the frothing tube and make sure there is
water in the water reservoir.
2. Aim the Frothed Milk Dispensing Tube into the empty cup.
3. Adjust the Froth Control Knob to Clean " ".
4. Press and hold the Latte/Clean "
pump starts, then release it. The clean function will
run for 30 seconds and then stop automatically.
To stop the process yourself, press the Latte/Clean
button " " again.
5. Once completed, throw the contents in the cup away.
6. The Frothed Milk Dispensing Tube is now clean and
the milk reservoir with milk can now be stored in the
refrigerator.
If completely cleaning milk reservoir, follow these cleaning instructions:
1. Place a large empty cup under the frothing tube and make sure there is
water in the water reservoir.
2. Aim the Frothed Milk Dispensing Tube into the empty cup.
3. Adjust the Froth Control Knob to Clean " ".
4. Press and hold the Latte/Clean "
release it. The clean function will run for 30 seconds and then stop
automatically. To stop the process yourself, press the Latte/Clean button "
" again.
5. Once completed, throw the contents in the cup away.
6. Remove milk reservoir from appliance and discard any remaining milk.
7. Rinse and wash all parts of the milk reservoir container and lid thoroughly
with warm soapy water. Rinse and dry well. Do not use abrasive cleaners
and scouring pads, as they will scratch the finish. The milk reservoir and lid
is also dishwasher safe (top rack).
CLEANING THE PORTA-FILTER, FILTER AND BREW HEAD
WARNING!: Some of the metal parts might still be hot. Do not touch them
with your hands until they have cooled.
1. Turn unit Off ("O") using the On/Off switch and unplug the power cord
from the electrical outlet.
2. Remove the porta-filter and discard the espresso grounds. Wash both the
porta-filter and filter with warm soapy water and rinse them well.
NOTE: The porta-filter and filters are not dishwasher safe.
" button until
" button until pump starts, then
15
9/30/13 2:33 PM