Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONNECTIONS, OPERATING AND DISPLAY ELEMENTS
2
The CLROOTPAR4 and CLROOTPAR6 models feature identical connections, operating and display elements.
POWER IN
1
Blue Power Twist mains input socket. Operating voltage 100–240 V AC/50–60 Hz. A suitable mains cable with Power Twist
plug is included.
POWER OUT
2
White Power Twist mains output socket for supplying power to additional Cameo spotlights (max. 8 A).
DMX IN
3
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
DMX OUT
4
Female 3-pin XLR socket for sending the DMX control signal.
FUSE
5
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated
fuse failure, please contact an authorised service centre.
OLED DISPLAY
6
The OLED display shows the currently activated mode (main display), the menu items in the selection menu and the numerical value or
operating mode in certain menu items. If there is no input for around two minutes, the display automatically returns to the main display.
Note regarding the main display in operating modes with external control: As soon as the control signal is interrupted, the characters in
the display begin to flash. When there is a control signal again, the flashing stops. Briefly pressing the UP button when in the main display
rotates the display by 180°.
CONTROL BUTTONS
7
MODE – press MODE to access the selection menu. Press repeatedly to go back to the main display. Pressing MODE without confirming a
value or status change with ENTER restores the previously confirmed value or status.
ENTER – press ENTER to access the menu levels, to make value changes, and to access the submenus. Confirm value or status changes by
pressing ENTER.
UP and DOWN – select individual menu items in the selection menu (DMX address, operating mode etc.) and in the submenus.
Allow changes to the value in a menu item, such as the DMX address, as required.
6
1
4
3
Tabla de contenido
