Important Details For Your Information - Tecsis P3290 Manual De Instrucciones

1. Important details for your information

1. Important details for your information
Read these operating instructions before installing and starting the pressure sensor.
Keep the operating instructions in a place that is accessible to all users at any time.
The following installation and operating instructions have been compiled by us with great care
but it is not feasible to take all possible applications into consideration. These installation and
operation instructions should meet the needs of most pressure measurement applications.
If questions remain regarding a specific application, you can obtain further information:
Via our Internet address www.tecsis.de

The product data sheet is designated as DD/DE721

Contact tecsis for additional technical support +49 69 5806-173

With special model number, e.g. P3290 or P3291, please note specifications in the delivery note.
If the serial number gets illegible (e.g. by mechanical damage or repainting), the retraceability
of the instrument is not possible any more.
tecsis pressure sensors are carefully designed and manufactured using state-of-the-art tech-
nology. Every component undergoes strict quality and environmental inspection
before assembly and each instrument is fully tested prior to shipment.
The P3290 / P3291 is a high-quality precision pressure measuring instrument. Installation-
related influences (e.g. position dependence, offset of your display unit or control unit, etc.)
of relative pressure equipment must be eliminated by correcting the zero point in your system
or via the Communication Software and the integrated interface at the instrument (details are
described in chapter 8). This gives you optimum measuring precision of the overall system.
Use of the products in accordance with the intended use:
Use the pressure sensor to transform the pressure into an electrical signal.
Knowledge required: Install and start the pressure sensor only if you are familiar with the
relevant regulations and directives of your country and if you have the qualification required.
You have to be acquainted with the rules and regulations on measurement and control techno-
logy and electric circuits, since this pressure sensor is „electrical equipment" as defined by
EN 50178. Depending on the operating conditions of your application you have to have the
corresponding knowledge, e.g. of aggressive media.
Betriebsanleitung/Operating instructions/Mode d'emploi/Instrucciones de servicio
GB
23