Assembly; Operating Instructions - Watts TRITON Manual De Instrucciones

Equipment Setup & Usage Instructions

Assembly

STEP 1
Attach Power Cord
NOTICE
Make sure power (On/Off) switch on
Control Unit is in Off position.
STEP 2
Attach Fuser Cord
• Locate the Fuser Cord . The Fuser Cord
has connectors on each end .
STEP 3
Attach Fuser
NOTE: Fusers for use with TRITON are sold separately.
• Push the other end of the Fuser Cord
onto the selected Fuser and lock in place
with a 1/4 turn .

Operating Instructions

WARNING
!
• BEFORE each use carefully check the
condition of the equipment . Do not use
if damaged in any way . Do not use if any
parts are missing .
• Review the equipment assembly and
make sure all connections are proper and
secure .
• Inspect the Power Cord and plug, confirm
that the electrical outlet is the correct
• Locate the Power Cord . The Power Cord
has a GFCI plug on one end and a female
connector on the other end .
• Locate the Power Cord receptacle on the
Control Unit .
• Insert the female end of the Power Cord
into the Power Cord receptacle on the
side of the Control Unit . Push female end
of Power Cord into receptacle securely .
• Locate the Fuser Cord terminal on the
side of the Control Unit . Push one end of
Fuser Cord into the terminal and lock in
place with a 1/4 turn .
• Make sure the jaws on the Fuser are
closed .
BEFORE each use review
this Manual, especially
the Important Safety
Information. Do not use the
equipment unless you are familiar with
safe and proper operation.
rating and properly grounded, and test
operation of GFCI plug .
• Make sure that work area is clean, well
lit, free of clutter, with no distractions, and
accessible only by authorized personnel
and workers .
• Make sure the Control Unit is firmly on the
ground or other stable work surface . Do
not place on ladder or shelf .
11