Important Safety Information
General Setup, Use, and Care Precautions
!
TO AVOID SERIOUS PERSONAL INJURY:
• Read Manual and all product labels
BEFORE using the equipment . Do not
use unless you know the safe and proper
operation of this equipment .
• Check equipment at least once per day
and BEFORE every use for damage and
signs of wear . Replace any worn, dam-
aged, or broken part BEFORE using .
• Do not use if the power (On/Off) switch
is not working properly or if the unit will
not power on . Equipment that cannot be
controlled by the power (On/Off) switch is
dangerous and must be repaired before
using .
• Do not substitute cords from other
manufacturers . Only use TRITON Power
Cords and Fuser Cords with the system .
Substituting alternative equipment may
cause personal injury or damage to the
equipment, or void the product warranty .
• Avoid accidental start-ups . Make sure
that power (On/Off) switch is in the "Off"
position before plugging (connecting) the
equipment into an electrical outlet (recep-
tacle) .
• Stay alert, pay attention to what you are
doing, and use common sense while
using or working near this equipment .
• Do not use this equipment while tired or
under the influence of drugs, alcohol, or
medications . Inattention, fatigue, and drug
and/or alcohol influence may result in seri-
ous personal injury .
• Always wear personal safety protection
when using the equipment . Dress properly
for the job . Use eye and hand protection
as appropriate to help minimize risk of
serious personal injury .
• Keep proper footing and balance at all
times, and do not overreach while using
the equipment .
• Place the Control Unit firmly on the
ground or a stable work surface . Do not
use the Control Unit on a ladder or shelf .
• Do not force the Fuser onto the Fitting .
• Do not use the Fuser for any purpose
other than making a weld as instructed
in this Manual . Using the Fuser as pliers,
a wrench, or a hammering device may
result in serious personal injury and can
damage the equipment .
• Use the carrying handle to transport,
move, or position the Control Unit for use .
• Unplug (disconnect) the equipment from
the electrical outlet (receptacle) when not
in use, or while performing service, repair,
or cleaning .
• Service or repair MUST be performed only
by trained and qualified technician .
• Turn off and unplug (disconnect) BEFORE
cleaning, servicing, or repair . NEVER
attempt to clean, service, or repair unless
the equipment is completely unplugged .
The person performing the cleaning, ser-
vice, or repair MUST keep the GFCI plug
under his exclusive control .
• Do not attempt to open the Control Unit
or Fuser case (housing) . There are no
serviceable parts inside the Control Unit
or Fuser .
• Only use authorized and manufacturer-
recommended repair and replacement
parts .
• Keep equipment (especially Fuser contact
surfaces) clean and dry .
• Do not clean equipment with abrasive,
caustic, or harsh cleaning fluid or chemi-
cals . Use only water with mild soap . Dry
with soft, clean cloth .
• Develop a periodic maintenance schedule
for this equipment .
• Store equipment in a clean, safe, and
secure place, out of reach of children and
unauthorized personnel or workers .
9