Parker AC10 Serie Manual De Instrucciones página 8

English
Drive Start-up

Read the Safety section at the front of the QuickStart.

Ensure that all local electric codes are met.

Check for damage to equipment.

Check for loose ends, clippings, filings, drilling swarf etc. lodged in the drive and system.

Check all external wiring circuits of the system - power, control, motor and earth connections.

Ensure that unexpected rotation of the motor in either direction will not result in damage, bodily harm or
injury. Disconnect the load from the motor shaft, if possible.

Check external run contacts are open. Check external speed setpoints are all at zero. 
Ensure that nobody is working on another part of the system which will be affected by powering up.

Ensure that other equipment will not be adversely affected by powering up.

Check motor stator connections are correctly wired for Star or Delta as necessary for drive output voltage.
Drive Setup
Before attempting to set up the drive, you will need some motor information. This is found on the motor
nameplate. The information you will need is listed below:
Base Volts, Base frequency
Base RPM
Full load amps
No load amps (mag current)
Connection (star or delta)
Basic Connections
0.2kW – 22kW Basic Wiring Diagram for Multi-stage speed control macro (PNP type)
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - [email protected]
1-6