SEVERIN SM 3734 Instrucciones De Uso página 13

completely covered.
∙ Insert the stopper into the lid.
∙ To add ingredients during operation, the
stopper in the centre of the lid can be
removed.
∙ Do not put any objects into the blender
jug while the appliance is operating.
∙ Insert the plug into the wall outlet and use
the rotary control to select the required
power setting.
∙ Caution: Do not operate when the
blender jug is empty. Do not fi ll it with dry
items only, such as nuts, almonds etc.
∙ After using the blender, switch off and
remove the plug from the wall socket.
Wait until the motor has come to a
complete standstill before removing the
blender jug.
Crushing ice
Ice-cubes can be easily crushed in the
blender jug:
Fill the jug a quarter full with ice cubes, and
then fi t it to the motor housing, as described
in the section Operation. Put on the lid with
the stopper in place, and use the pulse
function (P) to operate the appliance for
about 2 seconds. Wait until the ice cubes
have collected in the bottom of the jug again
and then repeat the process, until the cubes
have been reduced to the required size.
Wind-up power cord storage
The power cord can be wound up for storage
in the base of the motor housing. Unwind it
completely before operation.
Cleaning and care
∙ Always remove the plug from the wall
socket before cleaning the appliance.
∙ To avoid the risk of electric shock, do not
clean the motor housing or the power
cord with water and do not immerse them
in water. The motor housing may be
wiped with a slightly damp, lint-free cloth.
∙ Do not use abrasives, harsh cleaning
solutions or hard brushes for cleaning.
∙ For cleaning directly after use, fi ll the
blender jug with around 700 ml of
warm water and a little detergent. Let
the appliance run for a short period
as described in the section Operation.
Afterwards, rinse the blender jug, lid and
stopper with fresh water. All parts must
me thoroughly dried afterwards.
∙ These parts are not dishwasher-safe.
∙ If necessary, the sealing gasket on
the blender jug lid can be removed for
cleaning. Before the appliance is used
again, the gasket must be replaced.
∙ If required, the blade unit for the blender
jar can be detached for cleaning: fi rst
remove the collar under the jar by turning
it clockwise (see pic. A), and lift out the
blade unit (pic. B). Caution: The blades
are extremely sharp. The gasket in the
blender jug cannot be removed. Clean the
blade unit with a suitable brush. Wipe the
gasket with a moist cloth. To re-assemble,
place the blade unit on the gasket, fi t the
collar and lock it by turning it counter-
clockwise all the way, observing the
markings on the collar).
Information for testing institutes:
The following recipe may be used:
Mix 400 g soaked carrots and 600 g water
for 3 minutes.
13