SEVERIN KS 9765 Instrucciones De Uso página 23

– caused by the electrical motor within the compressor assembly;
during compressor start-up the sound level will be slightly higher
for a limited period of time.
– caused by the cooling agent flowing through the circuit.
The following table lists the possible malfunctions, their probable causes and solutions. In the event
of operational problems, check first whether a solution can be found using this table. If the problem
persists, disconnect the appliance from the mains power and contact our Customer Service
Department.
Problem
The appliance is connected to
the mains, but does not operate.
Abnormal noise can be heard
during operation.
Water is collecting on the
bottom of the unit.
Transporting the unit
The unit must be transported only in its vertical position.
Do not tilt it to more than 45°. During transport, ensure that the unit is properly secured and
protected against shock, vibration and shifting.
Disposal
This appliance has been manufactured from recyclable materials. After removing the plug
from the wall socket, the unit should be rendered unusable by cutting off the power cord
before being disposed of through special waste collection points in accordance with local
regulations. The refrigerant and the chemical agent in the insulation foam must be disposed of
through a competent agency. Take special care not to damage the cooling circuit before the unit is
handed over for competent disposal.
Guarantee
This product is guaranteed against defects in materials and workmanship for a period of two years
from the date of purchase. Under this guarantee the manufacturer undertakes to repair or replace
any parts found to be defective, providing the product is returned to one of our authorised service
centres. This guarantee is only valid if the appliance has been used in accordance with the
instructions, and provided that it has not been modified, repaired or interfered with by any
unauthorised person, or damaged through misuse.
This guarantee naturally does not cover wear and tear, nor breakables such as glass and ceramic
items, bulbs etc. This guarantee does not affect your statutory rights, nor any legal rights you may
have as a consumer under applicable national legislation governing the purchase of goods. If the
product fails to operate and needs to be returned, pack it carefully, enclosing your name and address
Possible cause and solution
The wall socket has no power, or there are contact problems.
Check the wall socket and the plug.
Either the unit has been improperly set up (e.g. on an uneven
floor) or there is contact between the rear-mounted cooling
circuit and the power cord, the wall or other object or surface.
Verify that all installation instructions in this manual have been
correctly complied with.
The melt-water drain system is blocked. Remove the blockage
and clean the system.
23