Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HOLDING THE UNIT
WARNING:
Always use the hand placements specified
below whether the operator is left-handed or right-handed.
This will help keep the operator slightly to the left of the
unit and out of the direct line of the saw chain if kickback
occurs (Fig. 10 and Fig. 11). Always keep all body parts to
the left of the chain line.
•
Always grip the unit firmly with both hands when the unit is
running.
•
Firmly encircle the handles and/or pole with the thumbs and
fingers (Fig. 7). This will help reduce the chance of losing control
of the unit if kickback occurs. Any grip with thumbs and fingers
on the same side of the handles and/or pole is dangerous (Fig. 8).
•
Stand in a stable position with feet apart and firmly planted.
As a Chain Saw
•
Hold the front handle with the left hand. Keep the left arm
straight to help withstand potential kickback.
•
Hold the rear handle with the right hand. Keep the right arm
slightly bent.
•
Do not cut above shoulder height. Do not overreach.
As a Pole Saw
•
Hold the pole with the left hand. Keep the left arm straight.
Always hold the pole in the grip area (Fig. 9).
•
Hold the rear handle with the right hand. Keep the right arm
slightly bent.
•
Hold the unit at waist level (Fig. 9).
•
Do not extend arms above shoulder height. Do not overreach.
CUTTING PROCEDURE BASICS
1. Start the unit. Refer to Starting Instructions in the Starting and
Stopping section.
2. Make sure that oil is flowing onto the guide bar and saw chain. A
small spray should be visible. When using the unit for the first
time, allow 30-60 seconds for the oil to begin flowing.
3. Press the unit against the wood and maintain a firm, steady
pressure through most of the cut. Do not put pressure on the
unit at the end of the cut.
4. Keep the unit running through the entire cut.
5. Do not try to force the saw through the wood. Allow the saw
chain to do the cutting. Exert only light pressure. Forcing the cut
could result in damage to the unit or personal injury.
6. Release the trigger as soon as the cut is completed. Allow the
saw chain to come to a complete stop. The saw chain, guide bar
and motor may experience unnecessary wear if the unit is run
without a cutting load.
Correct Grip
Thumbs Below the Handles
Incorrect Grip
Waist Level
Chain Line
Correct Stance
17
Fig. 7
Thumb
Above the
Handle
Fig. 8
Grip Area
Fig. 9
Fig. 10
Tabla de contenido
