Measuring Station - Hama TS33C Instrucciones De Uso

Ocultar thumbs Ver también para TS33C:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
Note
• During the connection attempt, the
measuring station radio symbol (1)
will flash.
• Do not press any buttons during
setup. Otherwise, values may not be
transmitted correctly and there is a risk
of value errors and inaccuracies.
• The setup process is completed when
the indoor and outdoor measurement
data is displayed on the base station.
• The measured value is automatically
updated by the base device about
every 45 seconds.
• If the temperature is outside of the
measuring range, LL.L (lower than
minimum temperature) or HH.H (higher
than maximum temperature) will appear
on the temperature display.
6.3. Selecting the channel/Other
measuring stations
Note
• You can connect up to three different
measuring stations to the outdoor
sensor. Ensure that the base and
measuring stations are set to the same
channel. Visit www.hama.com for
suitable measuring stations.
• The transmission channel on the
supplied measuring station can be
changed/set (CH1, CH2, CH3).
6.4. Low battery charge

Measuring station

If the batteries need to be replaced, the
symbol for low battery charge
appear next to the outdoor temperature
display on the base device. Replace the
batteries immediately.
Note – Replacing the
batteries
• Note that the stations have to be
resynchronised each time after you
change the batteries in the measuring
or base station.
• To do this, remove the batteries from
the other station and then reinsert
them, or change them as required.
6.5. Reset
Press the RESET button (3) to restart the
station. The measuring station returns to the
factory settings.
7. Care and Maintenance
• Only clean this product with a slightly
damp, lint-free cloth and do not use
aggressive cleaning agents.
• Make sure that water does not get into
the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability
and provides no warranty for damage
resulting from improper installation/
mounting, improper use of the product
or from failure to observe the operating
instructions and/or safety notes.
will
5
Tabla de contenido
loading

Este manual también es adecuado para:

0018630000104985

Tabla de contenido