Idiomas disponibles
Idiomas disponibles
will be heard indicating a reduced boiler
temperature. Should this occur, release
the steam jet button immediately to
prevent water from being emitted and
allow the boiler briefly to heat up again.
Automatic switch-off
The steam function will be automatically
switched off and put into stand-by mode if it
has not been used for approx. 15 minutes.
However, it can be re-activated by simply
pressing the steam jet button or the steam
output control. The stand-by function is
shown by the indicator light alternately
flashing green and red.
Dry ironing
- Insert the plug into a suitable wall socket.
- Press the steam output control three
times in order to switch off the steam
function.
●
If dry-ironing is required for a longer
period of time, the boiler must be
switched off by depressing and holding
the steam output control for approx. 4
seconds. The indicator light will now
show red.
- Set the temperature control knob to the
required ironing temperature according
to the ironing symbols.
- As the iron heats up, the indicator lamp
on the iron is on. The lamp goes out once
the required ironing temperature is
reached.
●
Replace the iron on its stand on the
steam generator after use, and remove
the plug from the wall socket.
General care and cleaning
●
Before cleaning the appliance, ensure it is
disconnected from the power supply and
has cooled down completely.
●
To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
●
Do not use abrasives or harsh cleaning
solutions.
- If necessary, the appliance may be wiped
with a dry lint-free cloth.
Iron
- Starch, fat and other deposits on the sole
plate may be removed with a woollen
cloth soaked in a vinegar/water solution.
- In order to protect the clean sole plate,
occasionally apply a small amount of
paraffin to the warm plate, wiping it off
with a woollen cloth.
- The steam outlet openings in the sole
plate are cleaned by repeatedly pressing
the steam jet button while holding the
iron over a sink or a suitable container.
Hot water and steam will be emitted
through the openings in the sole plate.
This will result in the removal of dust
particles.
To empty any water remaining in the
reservoir
After use, any remaining water must be
removed from the reservoir.
- Remove the water reservoir.
- Lift out the anti-scale insert upwards.
- Pour out any remaining water through
the filler opening.
- Replace the anti-scale insert.
- Place the reservoir back into the steam
generator.
Anti-scale insert
Depending on the water quality in your area
as well as frequency of use, the anti-scale
insert should be replaced at regular intervals.
Guidelines assuming 2-3 hours of use per
week:
Soft water
Medium-hard water
Hard water
Should you be unsure about the hardness of
the water in your area, please enquire at the
relevant local authority department.
If the anti-scale insert is empty, a new insert
should be installed without delay. Although
you will be able to use the steam generator
9
- after 6 months
- after 3 months
- after 6 weeks
