Intended Use; Power Supply - Makita M9800 Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Oscillation per minute
Oscillation angle, left/right
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to
EPTA-Procedure 01/2014, are shown in the table.

Intended use

The tool is intended for sawing and cutting wood,
plastic, gypsum, non-ferrous metals, and fastening
elements (e. g. unhardened nails and staples). It is also
intended for working soft wall tiles, as well as dry sand-
ing and scraping of small surfaces. It is especially for
working close to edge and flush cutting.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
Work mode Sound pres-
sure level
(L ) :
pA
Sanding 78 dB(A)
Cutting with 79 dB(A)
plunge cut
saw blade
Cutting with 79 dB(A)
segmental
saw blade
Scraping 78 dB(A)
The noise level under working may exceed 80 dB (A).
Vibration
The following table shows the vibration total value (tri-axial vector sum) determined according to applicable standard.
Sanding (a )
h
Cutting with plunge cut saw blade (a
Cutting with segmental saw blade (a
Scraping (a )
h
Uncertainty (K) Applicable
standard
3 dB(A) EN62841-2-4
3 dB(A) EN62841-1
3 dB(A) EN62841-1
3 dB(A) EN62841-1
Work mode
)
h
)
h
15,000 - 22,000 min
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration emission
2
2.5 m/s
2
8.0 m/s
2
4.0 m/s
2
9.5 m/s
4 ENGLISH
M9800
-1
1.6 ° (3.2 ° total)
283 mm
1.2 - 1.3 kg
/II
Uncertainty (K) Applicable standard
2
1.5 m/s EN62841-2-4
2
1.5 m/s EN62841-1
2
1.5 m/s EN62841-1
2
1.5 m/s EN62841-1