Electromagnetic Compatibility; Before Use; Operation - Hilti PUA 80 Manual De Instrucciones

k) Batteries that have reached the end of their life
must be disposed of safely and correctly to avoid
environmental pollution.

4.4 Electromagnetic compatibility

Although the appliance complies with the strict require-
ments of the applicable directives, Hilti cannot entirely
rule out the possibility of interference to the appliance
en
caused by powerful electromagnetic radiation, leading to
incorrect operation. Check the accuracy of the appliance
by taking measurements by other means when working

5 Before use

5.1 Connecting 1
1. Connect the supply cord to the appliance.

6 Operation

CAUTION
The appliance becomes warm while charging the battery. The appliance must therefore not be built-in, covered
over or used in a location where the air cannot circulate freely. Do not operate the charger inside a closed
container.
CAUTION
Never store or charge the battery in direct sunlight, on a radiator at a window or behind a pane of glass. The
battery will suffer damage at high temperatures.
6.1 LED indicators 1
NOTE
- Charge the battery only within the temperature range 0 to 40°C (+32°F to +104°F).
- Maximum charging efficiency is achieved at an ambient temperature of 0 to 30°C (+32°F to +86°F).
LED indicators
10
under such conditions or if you are unsure. Likewise, Hilti
cannot rule out the possibility of interference with other
devices (e.g. aircraft navigation equipment).
4.5 Liquids
Under abusive conditions, liquid may leak from the bat-
tery. Avoid contact. If contact accidentally occurs,
flush with water. In the event of the liquid coming into
contact with the eyes, rinse the eyes with plenty of
water and consult a doctor. Liquid ejected from the battery may cause irritation or burns.
2. Plug the supply cord into the power outlet.
3. Connect the charging cable to the PSA 80, PRA 82
or PRA 801 battery.
Green LED lights constantly
Green LED blinks
Red LED lights constantly
Red LED blinks
The appliance is connected to the elec-
tric supply and is in operation.
The battery cannot be charged. The
battery is either faulty or its temperat-
ure is outside the limits for successful
charging. Disconnect the battery from
the charger and allow it to cool down
or warm up accordingly. Subsequently
reconnect the battery to the charger. If
the green LED continues to blink, the
battery is faulty. Contact Hilti.
The battery is being charged.
Battery charging is complete.