Reversible door
∙ If required, the door may be reversed, i.e. from right-hinged
(default installation) to left.
∙ To avoid the risk of personal injury or damage to the unit,
two people are needed to reverse the door.
∙ Warning: Always disconnect the unit from the mains before
any maintenance or repair work is carried out.
∙ Before you start, please note the following:
∙ Always ensure that the correct number of washers is used
on all hinge bolts and screws.
∙ So that the doors can close tightly against the frame, take
the utmost care that they are properly aligned during re-
assembly.
1.
Remove the four screw covers from the top cover.
2.
Take out the four screws and remove the entire top cover.
3.
Tip the whole unit back until it is resting on its back.
However, ensure that it is lying on a soft, smooth surface
to prevent damage.
4.
Take off the upper hinge by removing the 3 screws. Take
off the upper door and place it on a soft surface to protect
it from scratches.
5.
Pull out the two bolts which hold the centre hinge in
position. Remove the hinge by slightly lifting the lower
door. Take off the door and place it too on a soft surface
to protect it from scratches. Remove the cover from the
upper left side of the freezer compartment door and fi t it
on the right side.
6.
Remove the three blind covers for the hinge mounting
holes and the screw covers on the left, and replace them
in the corresponding places on the right. .
7.
Unscrew and take off both adjustable feet. Remove the
screws holding the lower hinge and the mounting plate for
the left foot. Remove the screw covers from the left hand
side and replace them on the right.
17