Idiomas disponibles
Idiomas disponibles
Part number: 9835662980
Troubleshooting
Problem
Possible cause
LED ring
•
lights up
•
yellow
•
constantly
Red LED starts
•
flashing imme-
diately after the
charge card is
held against the
reader
Note: appli-
cable for RFID
cards/key fobs
only
Vehicle is on a timer
Vehicle is fully charged
Grounding resistance
is too high (with spe-
cific vehicles,
this must be
< 50 Ohm)
Charge card is not
authorized for
charging at this wall
box
Solution
•
Make sure that the charging cable
plug is properly connected to the
vehicle (check by user).
•
Change the setting of the timer in
the vehicle (check by user).
•
Replace the charging cable (us-
er-serviceable).
•
Make sure that the ground resis-
tance is correct (grounding
measurement done by an elec-
trician).
•
Make sure that the charge card/
key fob is registered correctly
(check by user).
•
If you have a Smart Wallbox con-
nected via Wi-Fi, make sure that
there is proper Wi-Fi reception
where the wall box is installed
(check by user).
If the Wi-Fi connectivity of your
smart wall box is lost, first reboot
your Wi-Fi router, then reboot the
wall box via your App and after-
wards check the Wi-Fi reception
again (check by user).
EN
EN
13
Capítulos
