Idiomas disponibles
Idiomas disponibles
1. Place the tent bed plate up
and make the tape connect with
the bed plateas the picture shows.
3. The tape in the cover pass through
the slots at the bedstead link.
4.Tent
1) Please check the car if
there are lengthways roof racks
on your car roof and
the distance between the rack
and the car roof is more than
3cm. Otherwise, you need to get
a set of suitable roof rack and
3) Adjust the tent to the appropriate
position on the car roof. (Remember
to make sure the trunk door can be
opened)
Tent PVC cover
17
2. Put the tape through the slot.
4. Finally, Cover the tent with a
PVC cover and zip up. The tent
with the PVC cover is finished.
2) According to the direction
and size of the roof rack.,loosen
the screws and adjust the
direction and distan ce of the
two connecting-tubes, tighten
the screws, then put the tent
onto the car roof.
4) Slide the all bolts with
slip fixed to appropriate position
on the connecting tube.
Please be noted, when the distance
between roof rack and car roof is
less than 4cm, the short bolts will
be used instead of the long bolts.
