DeWalt DWE74911 Manual De Instrucciones página 7

WARNING: Be sure that the locking pins have engaged and the
legs are firmly held in place.
4. With all legs locked in their open positions, pull stand toward you
and tilt over until all four feet are on the ground.
Transporting the Saw on
the Stand (Fig. 7)
COLLAPSING THE STAND FOR TRANSPORT
1. Lifting the stand by the handle, tilt up the stand until the saw is at
a 90 degree angle sitting on the kickstand.
2. Fold the handle-side legs by depressing the handle-side leg
release levers (C) and rotate until locking pin clicks into the detent
(O). Repeat the operation on the second handle side leg of the
stand.
3. Fold the wheel-side legs by rotating the wheel-side leg release
levers (D) with foot (or hand) and rotate until locking pin clicks into
the detent (O). Repeat with other wheel leg.
WARNING: Be sure that the locking pins have engaged and the
legs are firmly held in place.
FIG. 7
O
C
WARNING: To reduce the risk of personal injury, DO NOT operate
the table saw mounted to the stand with the legs folded and the stand
sitting on the ground.
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
Accessories
O WARNING: Since accessories, other than those offered by
D
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
E
this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286,
call 1-800-4-D
dewalt.com.
5
WALT recommended accessories should be used with
WALT (1-800-433-9258) or visit our website: www.
E
WALT
E