Idiomas disponibles
Idiomas disponibles
Thermal Motor Protection
The blender is equipped with a thermal
protector which protects the motor from
overheating. If the motor shuts down du-
ring operation, unplug the blender and let
it cool down for a minimum of 15 minutes
before continuing blending.
For Best Results
If blending action stops during blending
z
there may be not enough liquid to blend
efficiently. Add some more liquid or insert
the tamper and stir slowly.
For preparing small amounts of food use
z
a low speed level.
When
chopping
z
recommend adding a small amount
of water to improve the circulation.
After finishing, strain your chopped
ingredients.
Fill the jug in the following order: Liquids,
z
dry goods, leafy greens, soft ingredients,
hard or frozen ingredients, ice cubes.
If blending in manual mode, always start
z
on speed 1 and slowly increase to the
desired speed.
Use the baby food chopper (optional ac-
cessory, not available in every country) to
make an oatmeal baby pudding.
Troubleshooting
Problem
Blender does not operate
and all LEDs are flashing in
a steady pattern.
Liquid is splashing out of
the jug.
14
vegetables,
we
Potential Causes
Jug is not properly atta-
ched.
Lid gasket is not mounted
properly, loose or even
torn.
Jug lid or measuring cap
are not closed properly.
Jug is overfilled.
3.5 oz / 100 g oats (small leaf)
7.1 oz / 200 g soy milk
Cook oats with soy milk on medium heat
until liquid is fully soaked up. Cool down
for approximately 15 minutes. Fill 9 oz / 255
g oatmeal baby pudding in the baby food
chopper. Chop 15 seconds at maximum
speed.
Other food loads are not recommended.
(B) Care and Cleaning
We recommend cleaning the jug by using
the CLEAN program
time. The program will automatically stop
once it completes the cycle.
Fill the jug (3) with water (max. 32 fl.oz. /
1000 ml), add a few drops of dishwashing
soap and follow the steps as described.
For best results, run the CLEAN program
immediately after use. Make sure to tho-
roughly rinse and air-dry the jug after com-
pletion of the program.
Warranty and Service
For detailed information see separa-
te warranty and service leaflet or visit
www.braunhousehold.com.
Solution
Check the correct position
of the jug and of the lid.
Ensure that the gasket is
mounted properly.
Close the lid and measu-
ring cap.
Follow the maximum quan-
tity recommendation in the
processing table.
to prolong its life-
