Idiomas disponibles
Idiomas disponibles
EN
3) Connect to a power supply: connect the refrigerator to the vehicle 12/24V DC system directly, the
minimal cable cross-section as per the below table based on the overall length of wire between the
refrigerator and the battery.
It is highly recommended that the installation of the fridge is carried out by a qualified person.
Enough free wire needed to be kept for moving the fridge into the cabinet.
Wire length to refrigerator
Maximum 6m
Maximum 11m
Maximum 17m
4) Push the fridge into the cabinet carefully to avoid scratching the floor and the power cable
should be kept loosen.
Screw cover
5) Attach the fridge to the cabinet wall: the screw holder is built in the side wall of the refrigerator. A
hole needs to be drilled through the screw holder into the side panel.
Use a screw (M5, 15mm minimum) and fix it on the wall. After that use the screw cover to cover
the screw head (screws are not included).
6) Verify the installation: once the installation had been finished, check the continuity of the earth cir-
cuit and carry out all electrical safety testing provided by current regulations. Protect and fix the
cables in order to prevent accidental pulling of the cable from disconnecting it from the connec-
tions or coming into contact with hot parts with a temperature above 50° C or with sharp parts.
CARBEST Compressor fridge LR40L / LR50L / LR90L | 713505 / 713506 / 713507
Cable diameter
2.5 mm² (14AWG)
4.0 mm² (12AWG)
6.0 mm² (10AWG)
Screw
Screw holder
For example LR40L (713505)
20
