Idiomas disponibles
Idiomas disponibles
LED indicator
Meaning
lights
No indicator
The charging station is
light is on
not connected to the
mains.
Steady green
The boundary wire is
correctly connected.
The battery is fully
charged.
Flashing
The mower is charging.
green
Flashing red
The boundary wire is not
connected or is damaged.
4. OPERATION
1. Once the installation process is completed, the mower will be ready for use.
2. Press the
button until the mower switches on. The first time you do this, enter the
default PIN code (0000). To do so, press four times
in Fig. 9. (See section "Changing the PIN code" if you wish to change it).
Note:
-
The mower will switch off after 30 seconds if no operation is performed.
-
If an incorrect PIN is entered ten times, the mower will beep and then switch off. You can
try to enter the PIN again after 50 minutes.
-
The robot needs the correct PIN to charge.
-
While the robot is charging, it will stop emitting an electrical signal through the cable.
3. Press
and then
use the cutting knob to adjust the cutting height (the cutting distance is in relation to the
ground).
4. Press
and then
-
The mower will mow the lawn without interruption until its battery level is low. It will then
return to the charging station. When fully charged, if it is within the operating range, it will
automatically restart or remain on the charging station if it is outside the operating range.
to start the lawn mower. Before starting the mower, remember to
for the mower to go back to its charging station.
Action required
Check that the power cable is properly
connected to the charging station, and that
the charging station is connected to a suitable
power supply.
This is normal, no action is required.
This is normal, no action is required.
Check that both ends of the boundary wire are
securely connected.
Check the boundary wire for damage.
until number 0 flashes, as shown
CONGA GRASSHOPPER 300
ENGLISH
121
