Vision TC-HDMIIP/3 Manual Del Producto página 6

Notes:
1/ All Tx and Rx must be on same subnet
2/ Microwave transmitters typically do not provide enough bandwidth for this product
3/ For multicasting a standalone Gigabit switch is recommended
4/ Switch can be unmanaged since IGMP snooping DOES NOT need activation
DHCP
A DHCP switch assigns IP addresses to each end point, otherwise the end points default to
192.168.10.10 (Tx) or 11 (Rx).
MULTIPLE TRANSMITTERS
Only ONE transmitter can be used on a network. Setting up a virtual LAN allows you to use more
than one transmitter on a physical network. The systems are kept separate and cannot be used as
a matrix.
If more than one transmitter / receiver sets share same network create a Virtual LAN on the
network switch for each transmitter and receiver set.
Example:
Connect 15 transmitters to ports 1-15
•
Connect 15 receivers to ports 16-30
•
Create VLAN_1 and assign ports 1 and 16
•
Create VLAN_2 and assign ports 2 and 17 etc...
•
6