Toa WM-5325 Instrucciones De Uso página 4

Micrófono inalámbrico
Ocultar thumbs Ver también para WM-5325:
Idiomas disponibles

Idiomas disponibles

WH-4000A Headset Microphone
Adjustable band
1.4 m in length
Gooseneck
Windscreen*
Plug lock
ø3.5 mm
Microphone
*
Windscreens are also available as optional product WH-4000S.
WH-4000P Waist Pouch
6. BATTERY INSERTION
Step 1. Turn off the power switch.
Step 2. Remove the battery cover from the unit.
Slide the battery cover in the direction
indicated by the arrow while
pressing on
cover with a thumb as shown in the figure.
Battery replacement
• A brand-new AA alkaline battery will continuously operate the unit
for about 10 hours.
• When the battery capacity becomes low, the green LED of the
Power/ Battery lamps starts to dim, while the red LED to light.
When only the red LED lights, replace the battery with a new one.
In this condition, the unit transmits the remaining battery capacity
information to the tuner, causing the tuner's BATT indicator to light.
6
WH-4000H Headset Microphone
1.4 m in length
Gooseneck
Plug lock
ø3.5 mm
Microphone
Step 3. Insert an AA battery according to (+) and (–)
indications on the battery compartment.
Step 4. Replace the removed battery cover.
the
Red LED
Green LED
7. WHEN OPERATING ON RECHARGEABLE
CAUTION
Notes
Windscreen*
• When operating on rechargeable batteries, the optional
• For rechargeable batteries, be sure to use the optional
7.1. How to Charge
Step 1. Set the wireless
OFF position.
Note
Be sure to turn off the
when charging. Batteries cannot be correctly charged
if the power switch is ON.
Step 2. Place
wireless transmitter.
(Refer to p.
Step 3. Fully insert the wireless
transmitter
Charger.
The
Charging is completed in approximately 3 hours and the BC-5000's full-charge indicator lights green.
Notes
• If the red charging indicator does not light even if the wireless
charger, check to see if the
• The wireless
Note: For more information, please read the instruction manual enclosed with the
7.2. Charging Timing
Please charge the equipment immediately when green LED light is off
and red light is on during use.
When the battery alarm lamp on the receiver is on, the battery level of
the
transmitter
The
transmitter
Even though the battery remains enough, both green and red lights
might be on at the same time.
[Guidelines on the rechargeable battery operation time]
Continuous usage time: Approx. 13 hours
Notes
• When using the
a long period of time, be sure to charge it before use.
• The
WB-2000
operation interval becomes extremely short after prolonged repeated use, change the battery with a new
one.
When charging, never insert rechargeable batteries other than the
specified
WB-2000
battery in the wireless microphone (transmitter).
Charging any other than the
personal injury due to battery rupture.
BC-5000
WB-2000
transmitter's
power switch to the
transmitter's
power switch
the WB-2000
rechargeable
battery
in the
6
"Battery insertion.")
transmitter
into the
receptacle of the
BC-5000
Battery
BC-5000's
charging indicator lights red and charging begins.
transmitter
has been correctly inserted.
transmitter
becomes warm after charging completion, however this is not a failure.
is low as well.
will not be able to operate within a few minutes.
WB-2000
rechargeable battery for the first time or when using it after it has been stored for
battery is designed to cycle through about 500 charges and discharges. When the
BATTERY
WB-2000
battery may result in fire or
Battery Charger is required.
battery. Do not use other batteries.
1
Power switch
Note
Can be placed in either
backward looking or forward
looking orientation.
3
Charging indicator (red)
Full-charge indicator (green)
transmitter
has been inserted into the
BC-5000
Battery Charger.
Power/Battery lamps
transmitter
7
loading