Sawgmore FC5230 Instrucciones página 8

V. Environmental Protection
1. Battery Maintenance
Please confirm the positive (+) and negative (-) poles of the battery
before use.
Do not charge and burn the battery or mix it with old battery or other
types of batteries.
If you plan to store the product or not use it for a long time, take out
the battery.
Do not dismantle the battery or energy gathering ring to avoid liquid
leakage or rupture of the battery.
2. Battery Recycling
This product uses dry battery, which contains many heavy metals, acids,
alkalis and other substances. Leakage of these substances will pollute
the environment and threaten human health. Therefore, waste batteries
should be classified and recycled.
Recycling steps: When the equipment is off, press down the battery
cover lock button with your finger tip, remove the battery cover, and
then take out the battery.
(Note: Avoid producing short circuit between the positive and negative
ends of the removed battery and further causing harm.)
13
VI. Troubleshooting
Problem
The seal of the nozzle
holder is damaged, or
There is a leak between
the nozzle was not
the nozzle and the body
installed in the
proper position
The seal is damaged,
There is a leak in the
or there are
water inlet
impurities on the inlet
There is a leak in the
The seal is damaged
water tank
There is not enough
Not enough charge
water pressure
The device cannot
Not enough charge
start
The device is being used
The device is not
for the first time, or has
not been used in an
releasing any water
extended period
Loading new battery
button in the boot file
products does not
power on
Note: If you plan to store the product containing batteries for a short
time, ensure no magnetic field within 10cm around. The switch of this
product is Hall switch, and magnetic field will cause the product to start
automatically.
If you were not able to solve the problem with the troubleshooting
instructions above, please contact the vendor you purchased the device
from or visit a designated after-sales repair location.
Cause Solution
Contact the vendor for
repairs, or reinstall the
nozzle in the proper
position
Contact the vendor
for repairs
Replace the seal, or
contact the
vendor for repairs
Use after replacing with
new batteries
Use after replacing with
new batteries or contact
the dealer for repair
Add a suitable amount of
water to the nozzle
installation hole and try
again after reinstalling
the nozzle.
Push the button to the
shutdown gear and
push it again to the
power-on gear to start
normally
14