Sawgmore FC5230 Instrucciones página 6

III. Steps
Start: This is very important! Please install the battery before using
for the first use, and it can be used directly.
Step 1: Install the battery
Press the battery cover lock, and the battery cover will pop up. Remove
the battery cover, and install three AA batteries into the battery
compartment according to the marking of positive and negative poles.
Finally install back the battery cover.
Note: If you find water in the battery compartment before installing
the battery, pour out the water, dry the battery compartment, and
then install the battery for use.
Step 2: Fill the Water Tank
Rotate the water tank counterclockwise and pull it down
to remove the water tank. Then add water into the water
tank. After that, align the water tank with the buckle
point and rotate the water tank clockwise to install it.
Note: Ensure that the device is turned off before filling
the water tank.
09
Step 3: Install the Nozzle
Insert the nozzle into the hole on the top of the controller. You should
hear a "click" sound on successful installation. Rotate the nozzle to
adjust the direction of water outflow. If you need to replace the
irrigator, press and hold the uninstall button, then remove the irrigator.
Installation
Step 4: Before Use
Before using the device, lean slightly over the sink, extend the nozzle
into your mouth and aim it at the teeth, gums, or between the teeth.
Rotate the nozzle to adjust the direction of the water outflow so that it
is perpendicular to the part of your mouth you wish to clean. Ensure that
your mouth is open enough so that any water flows right out.
Note:
When using the oral irrigator for the first time, you might feel itching or
your gum might be bleeding slightly, which is a normal phenomenon
and usually stops within 1~2 weeks.
Replacement
10