SOMFY SONESSE2 40 ZIGBEE Manual De Instrucciones página 4

EN
2.1.2.Preparing the drive
ü Check that the inner diameter of the motorised product's tube is greater than 37 mm.
1] Fit the accessories required to integrate the drive into the winding tube: fit the
crown (a) and the drive wheel (b) to the drive.
CAUTION
The crown is mandatory.
2] Measure the length (L) between the inner edge of the drive head and the rim
of the drive wheel.
2.1.3.Preparing the tube
1] Cut the winding tube to the required length, depending on the motorised
product.
2] Deburr the winding tube and remove the swarf.
3] For winding tubes which are smooth inside, cut a notch with the following
measurements: l = 7 mm, L = 10 mm.
2.1.4.Assembling the drive-tube
1] Slide the drive into the winding tube. For winding tubes with a smooth
interior, position the cut notch on the crown.
2] The drive wheel must be locked in place to prevent any movement in the
winding tube: This can be achieved by fastening the winding tube to the drive
wheel using 4 self-tapping screws, Ø 5 mm, or 4 steel pop rivets, Ø 4.8 mm,
placed between 5 mm and 15 mm from the outer edge of the drive wheel,
regardless of the winding tube.
CAUTION
The screws or pop rivets must only be fastened onto the drive wheel and not on the drive.
2.1.5.Installing the drive-tube assembly
CAUTION
• The motorised product must not be compressed between the brackets.
• Do not use the plastic cross without the metal bracket adapter.
The drive can be fixed directly onto the drive bracket (the screw holes are spaced
29 mm apart). Use 2 screws 4 x 8 mm delivered with the motor. A manual tightening
torque of 1.5 N·m is recommended.
Drive plates are also available in the current catalogue (Select the correct drive plate
adapted to the bracket and check the torque requirements in the system). Use the 2
screws 3 x 6 mm delivered with the motor plate. A manual tightening torque of
0.6 N·m is recommended.
1] Screw the bracket adapter to the drive head.
2] Install and fix the drive-tube assembly onto the end bracket (c) and onto the
drive bracket (d).
4
1]
1]
2]
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
SONESSE2 40 ZIGBEE
b
a
L = ...
L
2]
L
c
d