WAGNER STEAMFORCE SPEED PRO Guia Del Usuario página 25

SteamForce Speed Pro
•
Place the water tank on a flat surface with the tank opening facing upwards, unscrew
the tank cap and pour in the prepared descaling solution (Fig. 4).
•
Screw the tank cap back in place and check that it is tight.
•
Open the cover and remove the boiler (Fig. 7+8).
•
Empty the boiler completely.
If the boiler is not completely emptied, the descaling programme will not start
i
and an acoustic signal will sound (5 beeps).
•
Insert the boiler into the device and hand-tighten the cover.
•
Put the water tank back into the device.
•
Switch on the device.
•
Press the CLEAN button for about 3 seconds to start the automatic descaling
programme (an acoustic signal sounds and the descaling indicator starts flashing).
•
When descaling is complete (duration approx. 20 minutes), an acoustic signal sounds
again and the descaling indicator goes out.
•
Switch off the device.
•
Clean all connections on the appliance, hose and steam plate.
•
Blow through the steam hose with compressed air to remove deposits and prevent a
malfunction.
•
Hold the water tank by the sides and pull it out of the device (Fig. 3).
•
Open the cover and remove the boiler (Fig. 7+8).
•
Rinse the unit thoroughly two or three times with clean water in order to remove any
remaining descaling solution.
Before reinserting the boiler, check whether condensation has collected at the
i
bottom of the device and, if so, remove it (Fig. 9).
If no further work is done after descaling, run the machine again with clear
i
water for approx. 20 seconds.
11. Storage
•
Allow the device to cool down.
•
Hold the water tank by the sides and pull it out of the device (Fig. 3).
•
Open the cover and remove the boiler (Fig. 7+8).
•
Rinse out the water tank and boiler with clean water and empty them completely.
•
Check whether condensation has collected at the bottom of the device and, if so,
remove it (Fig. 9).
•
Insert the boiler into the device and hand-tighten the cover.
•
Put the water tank back into the device.
•
Store the hose, steam plates and power cable in the designated places (Fig. 10).
EN
25