Idiomas disponibles
Idiomas disponibles
EN
18
Troubleshooting guide
8. TROUBLEShOOTING GUIDE
OPERATIONAL
ISSUE
Detergent is not
dispensing
Detergent to water
ratio
POSSIBLE CAUSE
Detergent is not
pressure washer
approved
The suction tube
has become
disconnected,
clogged or kinked
Detergent nozzle is
clogged with debris
SOLUTION
Use only detergents, degreasers, waxes and
other cleaning solutions that are designed
specifically for pressure washers. Cleaners in
this category will clearly state on the label that
they are meant for use in pressure washers. Do
NOT use any other type of cleaning solution in
your high-pressure washer. Never use bleach,
ammonia, any type of acid or hot water in your
appliance!
Ensure the suction tube is not damaged and
is properly connected to the detergent nozzle.
Reconnect, clean or replace the tube as
needed.
Clean the nozzle according to the instructions
provided in the Nozzle paragraph under the
Maintenance section of this manual.
The pressure washer draws detergent at a
maximum 10:1 water to detergent ratio. Most
pressure washer detergents are concentrated
within this range so minimal adjustment of the
detergent nozzle metering valve is required. If
you feel you are using more detergent than is
required for the application, you can dilute the
detergent with regular tap water.
FDW 2002 E
