Idiomas disponibles
Idiomas disponibles
EN
14
Assembly instructions | Starting
ATTENTION! CAUTION:
Damage may occur to painted surface if soap is allowed to dry on the surface. Wash and
rinse a small section at a time.
.Apply the solution to a DRY work surface.
Note: WETTING THE SURFACE FIRST IS NOT RECOMMENDED, AS IT DILUTES THE
DETERGENT AND REDUCES ITS CLEANING ABILITY.
Allow detergent to remain on the surface for a short time before rinsing.
Rinse with clean water under high pressure. On a vertical surface, first rinse from the bottom
up, then rinse from the top down. Hold nozzle 6 – 8 in in (15-20 cm) from the work surface at
a 45° angle using the flat spray as a peeling tool rather than a scrub brush.
Note: Ensure that the detergent injection system is completely clean prior to switching from
one detergent to another
6. STARTING
ATTENTION! DANGER:
Risk of injury from spray. Always engage the trigger lock when gun is not in use. Failure to do
so could cause accidental spraying.
ATTENTION! WARNING
Risk of Injury. Do not direct discharge stream at self or others.
ATTENTION! WARNING
Risk of unsafe operation. Stand on a stable surface and grip gun/ spray wand firmly with
both hands.
Connect the high pressure hose to the machine outlet. Ensure the threads are aligned
properly and the connection is secure.
FDW 2002 E
