Idiomas disponibles
Idiomas disponibles
REPLACING BATTERY
_WARNING:
Do notshort batteryterminals
by allowing a wrench or any other object to
contact both terminals at the same time.
Before connecting battery, remove metal
bracelets,
wristwatch
bands, rings, etc.
Positive terminal must be connected first to
prevent sparking from accidental grounding,
1. Lift hood to raised position.
2. DisconnectBLACKbatterycable(A)
then
RED battery cable and carefully remove
battery from tractor.
3. Install new battery with terminals insame
position as old battery.
4. First connect RED battery cable (B) to
positive (+) battery terminal with hex bolt
and keps nutas shown. Tighten securely.
Slide terminal cover (C) over terminal.
5. ConnectBLACKgrounding
cableto neg-
ative (-) battery terminal with remaining
hex bolt and keps nut. Tighten securely.
6.
Close hood.
Negative
(Bfack)
Cable
Positive
(Red)
Cable
TO REPLACE HEADLIGHT BULB
1, Raise hood.
2. Remove bulb holderfrom the hole inthe
backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the
backside of the grill,
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO REPLACE FUSE
Repface with 30 amp automotive-type plug-
in fuse, The fuse holder is located behind
the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
1. Raise hood.
2. Unsnap headlight wire connector,
3. Stand in front oftractor.
Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. Whenreplacing hood, besuretoreconnect
the headlight wire connector,
d
Headlight W ire
Connector
TRANSMISSION REMOVAIJREPLACE-
MENT
Should your transmission require removal
for service or replacement, it should be
purged after reinsta[Iation and before op-
erating the tractor. See "PURGE TRANS-
MISSION" in the Operation section of this
manual.
ENGINE
TO ADJUST
THROTTLE
CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual,
TO ADJUST CHOKE CONTROL
The choke control has been preset at
the factory and adjustment should not be
necessary. If adjustment is necessary, see
engine manual.
TO ADJUST CARBURETOR
Your carburetor has been preset atthe factory
and adjustment should not be necessary.
However, minor adjustment may be required
to compensate for differences in fuel, tem-
perature, altitude or load. If the engine does
need adjustment, see engine manual.
3O
