Idiomas disponibles
Idiomas disponibles
WARNING
DO NOT USE A CUTTING ATTACHMENT
WITHOUT AN APPROVED AND CORRECTLY
ATTACHED CUTTING ATTACHMENT GUARD.
ALWAYS USE THE RECOMMENDED CUTTING
ATTACHMENT GUARD FOR THE CUTTING
ATTACHMENT THAT YOU USE. USING
AN INCORRECT OR FAULTY CUTTING
ATTACHMENT GUARD CAN CAUSE SERIOUS
PERSONAL INJURY.
1.
Stop the product and remove the battery.
2.
Visually inspect for damage, such as cracks.
3.
Replace the cutting attachment guard if it is
damaged.
3
SERVICE
Servicing requires extreme care, and knowledge
and must be performed only by a qualified service
technician. Consult your nearest AUTHORIZED
SERVICE CENTER for repair. Call 1-855-345-3934 to
obtain the address. Only use identical manufacturer's
replacement parts and accessories from the
AUTHORIZED SERVICE CENTER.
4
ASSEMBLY
This section describes how to assemble and adjust the
product.
WARNING
CAREFULLY READ AND UNDERSTAND THE
SAFETY CHAPTER AND THE ASSEMBLY
INSTRUCTIONS BEFORE YOU ASSEMBLE THE
PRODUCT.
4.1
INSTALL THE TRIMMER GUARD
WARNING
• THE STRING CUT-OFF BLADE MUST ALWAYS
BE EQUIPPED ON THE TRIMMER GUARD
BEFORE OPERATING THE PRODUCT.
• DO NOT TOUCH THE STRING CUT-OFF
BLADE.
1.
Remove the screws from the trimmer guard with
a Phillips head screwdriver (not included).
2.
Place the trimmer guard onto the shaft.
3.
Securely tighten the screws with a Phillips head
screwdriver.
English
4.2
ASSEMBLE THE SHAFT
1.
Loosen the screw on the coupler with the hex
wrench.
2.
Push in the release button (1) on the lower shaft.
3.
Align the release button with the mounting hole
(2) and slide the two shafts together.
1
EXERCISE CAUTION WHILE SLIDING THE TWO
SHAFTS TOGETHER TO PREVENT ANY RISK OF
PINCHING YOUR HANDS OR FINGERS.
4.
Turn the lower shaft until the button locks into the
mounting hole.
7
2
CAUTION
EN
