Idiomas disponibles
Idiomas disponibles
Toggle
7. Install the Stopper
The drain stopper should have a 1/8" (3 mm) clearance between
the bottom of the threaded rod and the floor of the drain elbow.
If adjustment is required, remove the stopper assembly from the
drain and loosen the jam nut just below the stopper.
Turn the jamb nut counterclockwise to raise the stopper or
clockwise to lower the stopper.
Tighten the nut.
8. Complete the Installation
Make sure all connections are tight.
Open the drain.
Turn on the main water supply and check for leaks.
Kohler Co.
Stopper
Adjusting
Block
Nut
Adjusting
Rail
9
Lift Rod
Assembly
Screw
1018842-2-B
